Thread: Damn's 383 LT1 sneak peak!

nice motor build dustin goodluck with everything!

Makes me want to rebuild mine with forged internals too... Stupid old ass block lol... Does anyone have a ballpark figure of how much a forged 346 would run?

Nate can tell ya!

just depends what pistons and rods you wanna go with....If you want pm me some ideas we can bounce back and forth and figure out what rod and piston meets your budget and power needs.

Originally Posted by 00ls1z

Makes me want to rebuild mine with forged internals too... Stupid old ass block lol... Does anyone have a ballpark figure of how much a forged 346 would run?

You calm down over there! Lol. Just build a motor on the side and. Take your time....lol.

lol yeah i guess doing it on the side would be the best way lol...

when is this going to be done???

Probably be done in about 2 months or so maybe longer if i keep adding shit to it like i have been. It started out as just a stock short block rebuild and led to a fully built all forged 383. My head's should be done in a week i'm waiting to put the 2.05 valves in em and then i got to get the custom grind camshaft and valve train.

After the engine is finished i need to get the 1-7/8in long tubes the electric water pump the fuel system a stall and some other little shit.

Should be ready by summer though!

Make sure to unshroud the new larger valve,or the extra time and money involved in going to a 2.05 intake valve will be a waste.

Originally Posted by Nate @ All Out Performance

Make sure to unshroud the new larger valve,or the extra time and money involved in going to a 2.05 intake valve will be a waste.

Right don't they cut or gring out the old seat and put a new one in? I dont know a whole lot about building engines so if thats wrong hopefully you know what i mean.

Originally Posted by 00ls1z

Makes me want to rebuild mine with forged internals too... Stupid old ass block lol... Does anyone have a ballpark figure of how much a forged 346 would run?

Dude it wouldnt be that much!! Shit all you would need is some good pistons and rod's maybe ARP hardware and you would set with the bottom end! I would spend your money on some good head's and you would be soo fast!